CM3 DevKit

Article sections

    This page summarizes device-specific settings and supported peripheral hardware for Raspberry CM3 DevKit. Please read the main RPi3 tutorial to make understand basic concepts.

    Installation

    • Please read the official documentation for detailed steps how to mount the internal memory.
    • Flash emteria.OS to the mounted eMMC partition with emteria installer by choosing the “CM DevKit” target.

    Supported Hardware

    Touchscreen

    Support for the Raspberry Pi 7″ touchscreen:

    • Follow the official documentation to setup the proper wiring and download the dt-blob binary. Don’t forget to connect 5V and GND pins of your touchscreen, since the official documentation assumes them to be wired.
    • Follow the main RPi3 section to set the 800×480 resolution by using the FKMS overlay.

    Camera

    Built-in support for CSI camera modules. Configuration according to the official documentation.

    Did this article answer your question?

    Comments are currently closed.