Article sections
This page summarizes device-specific settings and supported peripheral hardware for Raspberry CM3 DevKit. Please read the main RPi3 tutorial to make understand basic concepts.
Installation
- Please read the official documentation for detailed steps how to mount the internal memory.
- Flash emteria.OS to the mounted eMMC partition with emteria installer by choosing the “CM DevKit” target.
Supported hardware
Touchscreen
Support for the Raspberry Pi 7″ touchscreen:
- Follow the official documentation to setup the proper wiring and download the
dt-blob
binary. Don’t forget to connect 5V and GND pins of your touchscreen, since the official documentation assumes them to be wired. - Follow the main RPi3 section to set the 800×480 resolution by using the FKMS overlay.
Camera
Built-in support for CSI camera modules. Configuration according to the official documentation.