Article sections

    Time needed: 15 minutes.

    In this tutorial you will learn how to physically connect your Raspberry Pi to an UART Bridge and additionally how to connect to your device and gather logs using PuTTY:

    1. Enable UART connection

      Connect your SD card with emteria.OS to your PC and mount the boot partition.
      Open config.txt and add following line: enable_uart=1
      Open cmdline.txt and change console=serial2 to console=serial0
      Save the files, safely remove the SD card, and put it back into your Raspberry Pi.

    2. Connect your RPi …

      Connect Pin 6 (GND), Pin 8 (GPIO 14 / TXD), and Pin 10 (GPIO 15 / RXD) …

    3. … to your UART Bridge

      … to the Ground, RXD, TXD Pin of the Bridge, respectively.

      This leads to:
      Ground of the Bridge to Pin 6 (GND) of the RPi
      RXD Pin of the Bridge to Pin 8 (GPIO 14 / TXD) of the RPi
      TXD Pin of the Bridge to Pin 10 (GPIO 15 / RXD) of the RPi

    4. Look up COM port

      Connect the UART Bridge with your computer and open computer management.
      Look for COM & LPT Ports. You will need the number of the COM port in a next step.
      Depending on your windows version you might need to install the Virtual COM Port drivers of the UART Bridge manufacturer.

    5. Download PuTTY

      Get the latest version of PuTTY from https://www.chiark.greenend.org.uk/~sgtatham/putty/latest.html
      Download, install and open it.

    6. Configure serial connection

      Switch to the serial category. Enter the COM port that you determined from computer management.
      Configure the serial line:
      Speed (baud): 115200
      Data bits: 8
      Stop bits: 1
      Parity: None
      Flow control: None

    7. Enable logging

      Switch to logging category. Select all session output and an appropriate file.

    8. Save session and connect

      Switch to the session category. Select serial as a connection type. Enter a session name and click save. It will appear in the list below. This is handy for the future. If you restart PuTTY you won’t have to reconfigure the serial connection and logging, but just load the appropriate session. Click open afterwards.

    9. PuTTY terminal

      After you click open a new window is opened. Power up your device and you should see the boot up log.
      If your device already booted up successfully and is idle you will just see a black window:


      Click into the window and press enter. The RPi Shell shall appear.

    10. Android log

      Having the RPi Shell you can use logcat to get android logs.


      All output of the terminal should be saved in the file you have selected in the logging category of PuTTY.
      If the black window remains and you don’t get to the shell, start from step one and check once again.

    Did this article help you?